Interlogix Monitor XL Hardware Guide Manual de usuario descargar pdf (Pagina 32)

28 Monitor ISM/xL™ Hardware Guide

22-0375 rev1.1

Vigil Module for use in the UK

Standard

Tamper

Pins

LED Bus

communications

indicator

TB1

Vigil Module

1432

XXXXX

1432

Module Bus

Data A

Data B

(+) 12V

red

green

yellow

black

Tamper Pins

1/2 AMP

P/N 342-3356

Module Bus

Data A

Data B

(+) 12V

red

green

yellow

black

1 AMP

P/N 342-3350

1432

red

green

yellow

black

red

green

yellow

black

Clock

Data

(+) 12V

Clock

Data

(+) 12V

Vigil Concentrator

Bus

Vigil

Concentrator

Bus



TB1A

TB2A

TB2

2 identical MONITOR Module

Bus connections. Can be

interconnected between main

panel and other modules on one

connector. Leave one connector

open to connect LCD service

keypad for convenience.

2 identical Vigil Concentrator

Trunk Line connectors.

Vigil

Concentrator

# 1

Vigil

Concentrator

# 2

These jumper

pins not used

and left open



These tamper pins engage

when drill through housing

version used to monitor short

between housings.

5 digit serial

number to

program in

MONITOR

Module

Programming

NOTE: A Vigil Concentrators can be

any of a number of varied types of

modules used in a Vigil System.

Similar to the Modules used with a

MONITOR System.



Module Programming

• The Smart/Vigil Module is capable of 64 input points and 80 output points to match the number available with a

full size Chubb Smart system.

• For easier programming of inputs/outputs the Smart/Vigil module must occupy the first module position in the

ISM/AFx Module Group.

• Enter the module’s 5-digit address in Module programming.

• It may be left assigned to Area 1 and enable the module’s tamper.

• Inputs and outputs are programmed differently from other modules to achieve the full amount on a Chubb

Smart/Vigil system.

• The Smart/Vigil module is 3 modules in one. It has 3 module group addresses.

• If a Smart/Vigil module was taking over a full 64 inputs and 80 outputs, this first address would be programmed

with “7” = 32 inputs and “7” = 32 outputs.

• Press Save. In the following module address, enter the next consecutive number after the last address. E.g. if the

Smart/Vigil module’s original address number was “

15281” in this second module address enter “15282”.

• Program the same as the last address with “7” = 32 inputs and “7” = 32 outputs.

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 65 66

Comentarios a estos manuales

Sin comentarios

Interlogix Monitor XL Hardware Guide Manual de usuario Pagina 32

Comentarios a estos manuales

Relacionado con productos y manuales para Panel De Control Interlogix Monitor XL Hardware Guide