Interlogix Monitor XL Hardware Guide Manual de usuario descargar pdf (Pagina 15)

22-0375 rev1.1 Monitor ISM/xL™ Hardware Guide 11

Authority Levels

Turn System ON

Turn System OFF

Turn System to STAY

Bypass Zones

Remove Bypass

Test System

Edit Users

Reset Alarms

Output Key Use

MASTER enter “2”

        

RESIDENT enter “3”

     

 

GUEST enter “4”

  



CLEANER enter “5”



Adding an Electronic Siren

• If it is necessary to add an electronic siren with a built in driver, the recommended connection is to use the on

board form “C” relay.

• An additional power supply must be added, as the Suite Security module does not have sufficient power to run a

siren.

• Connect the siren’s negative power connection to the power supply’s negative supply.

• Connect the power supply’s positive connection to the Suite Security module’s output # 1 relay common

connection.

• Connect the siren’s positive connection to output # 1 relay normally open connection. Program output # 1 to follow

when the area is in alarm (fire/burglary).

• When the area is in alarm, output # 1 will trigger and supply power to run the siren.

• The maximum number of Suite Security Modules that can be connected to one Main Panel is 60 and is separated

into 30 daisy chained on data connection: Module Bus 1 and 30 daisy chained on data connection: Module Bus 2

of the main control board.

• The ratio between the number of Suite Security Modules that can be used and regular modules that can be used

on one Main Panel is 5 Suite Security Modules for every 1 regular module.

• It is important to consider power requirements in big Suite Security Module systems. Adequate power supplies

must be added to the Suite Security Module cable runs and paralleled onto the Module Bus connections of the

Suite Security Module on the run that is designated where more power will be needed. Remember to add an

isolating diode to the Module Bus 12VDC connection at the Main Panel’s control board end as described in

Appendix “A”, “Adding a power supply to the Module Bus”, of this document. Otherwise, “Battery Trouble” will

occur.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 65 66

Comentarios a estos manuales

Sin comentarios

Interlogix Monitor XL Hardware Guide Manual de usuario Pagina 15

Comentarios a estos manuales

Relacionado con productos y manuales para Panel De Control Interlogix Monitor XL Hardware Guide