Interlogix Monitor XL Hardware Guide Manual de usuario descargar pdf (Pagina 10)

6 Monitor ISM/xL™ Hardware Guide

22-0375 rev1.1

No Commands (Simple Access)

Door Mode <Login> Notes

Card Only <card> If a UID/PIN is entered, it will be ignored

Card & PIN <card> <pin> UID is not required since the card

automatically identifies the <uid>

Card or UID/PIN <card> or <uid> <pin>

UID/PIN Only <uid> <pin> If card is presented, it will be ignored.

<uid> – User ID

With Commands

Door Mode <cmd> <Login> Notes

Card Only <cmd> <card> If a UID/PIN is entered, it will be ignored

Card & PIN <cmd> <card> <pin> Card badging must always be done before

the PIN entry.

Card or UID/PIN <cmd> <card> or

<cmd> # <uid> <pin>

Pressing “#” is required between the

command and uid/pin entry.

UID/PIN Only <cmd> # <uid> <pin> Pressing “#” is required between the

command and uid/pin entry. (Note

<cmd> # <pin> in PIN Only systems)

<cmd> – Command

NOTES:

<login> requires your <card> OR alternatively, your uid/pin.

E.g. <3 digit UID> <4 digit PIN>. Leading zeros cannot be omitted in UID or PIN.

Example 1: Arm area using card – enter <  3 card >

Example 2: Work late for 3 hours using uid/pin – enter <  6 3 # 001 1234 > for user 001 with pin 1234

Example 3: Access area without using card – enter < 001 1234 > for user 001 with pin 1234.

Using Duress Pin at Arming Station

• A Duress Pin (reversing last 2 digits of a user’s pin entered on the keypad to transmit a potential hold-up

condition) can be used at an Arming Station if the duress feature has been enabled in the System Group.

LED Indicators

Work Late LED

• Turns on if the area the Arming Station is assigned to is scheduled.

• Turns on solid 15 minutes before scheduled closing time.

• Does not operate if the area is not scheduled.

Door State LED

• Solid red if the door is locked.

• Solid green if the door is unlocked.

• Flashing red during disarming if there had been an alarm in the area.

Armed LED

• When activated, armed LED only stays on for the duration of the area’s Entry/Exit Delay during the following area

arming state changes.

– Momentarily solid green when the area is disarmed to OFF.

– Momentarily solid red when the area is armed to STAY.

– Momentarily flashing red when the area is armed to Fully ON.

Arming Station Internal Buzzer Indications

• Entry/Exit tones same as LCD keypad.

• Fire Siren – intermittent tone.

• Burglary Siren – steady tone.

• Bad Command Entry – double short beeps.

• Command accepted – single long beep.

• Unauthorized to perform command – double long beep.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 65 66

Comentarios a estos manuales

Sin comentarios

Interlogix Monitor XL Hardware Guide Manual de usuario Pagina 10

Comentarios a estos manuales

Relacionado con productos y manuales para Panel De Control Interlogix Monitor XL Hardware Guide