Interlogix Concord 4 REV J Installation Manual Manual de usuario descargar pdf (Pagina 80)

Chapter 3: Programming

74 Concord 4 Installation Manual

Device ID

Default: None

This menu lets you change the bus device ID number when replacing a

defective bus device.

To change a device ID:

1. With the display showing the desired bus device, press #, #. The

display shows DEVICE ID (current ID).

2. Enter the ID of the new bus device. The display flashes the entered

selection. Press # and the display shows the new setting.

3. Exit programming mode.

4. Remove AC and battery power from the panel.

5. Replace the defective bus device with a new one.

6. Apply AC and battery power to the panel.

Partition assign

This menu lets you assign bus devices to work in the desired partition.

Note: SuperBus 2000 8Z input modules, SuperBus 2000 4-relay output

modules, and SuperBus 2000 RF receivers are not assigned to

partitions.

To assign bus devices to partitions:

1. With the display showing the desired bus device, press #.

2. Press A or B until the display shows DEVICE PTN and then press

#. The display shows PARTITION ASSIGN n.

3. Press 1 to 6 to select the desired partition. The display flashes the

entered selection. Press # and the display shows the new setting.

1 2 ... 75 76 77 78 79 80 81 82 83 84 85 ... 152 153

Sin comentarios

Interlogix Concord 4 REV J Installation Manual Manual de usuario Pagina 80