Interlogix Concord Express Installation Manual Manual de usuario descargar pdf (Pagina 21)

Chapter 1

Concord Express Installation Instructions 15

Figure 8: Connecting N/C and N/O intrusion detection circuits

Figure 9 below shows the typical wiring for Optex model RX-040 (PI) PIR motion

detectors. The minimum available panel voltage for hardwired PIR motion

detectors is 8.5 VDC (9.1 VDC for UL Listed systems).

Figure 9: Connecting a PIR motion detector

Connecting 2-Wire Smoke Detectors

Zone input 6 can be set up (in program mode) to accept 12 VDC, 2-wire smoke

detectors by the following manufacturers:

• System Sensor models 2100D, 2100TD, 2100S, 2100TS, 2400, 2400TH

• Sentrol (ESL) models 429AT, 521B, 521BXT—models 521B and 521BXT

require the

following dip switch settings: 1-on, 2-off.

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 116 117

Sin comentarios

Interlogix Concord Express Installation Manual Manual de usuario Pagina 21