Interlogix NX-4V2 Installation Guide Manual de usuario descargar pdf (Pagina 4)

• To program tone dialing, enter 15 in the segment wh

tone dialing begins.

ere

• If the entire number is tone dialing, enter 15 in the first

segment.

• Enter 11 for a *, and 12 for a #.

Caution: A call-waiting cancel on a non call-waiting line

prevents successful connection to the central station.

Location 1 - Phone 1 account code

Location 1 has six segments of numerical data. Use this

ne 1 is

in the

smit

n those listed, review

the override options described in “Location 18 - Custom

to build the appropriate

al format (in addition to

ocation 18). s 0. If this location

ntains a 0, the built-in co nd the NX-

2 fu cal-on

Table 4: Communicator form

location to program the account code sent when pho

dialed. The default for each segment is 10. Program a 10

segment immediately after the last digit of the account code. If

the account code is six digits long, program all six segments

Location 2 - Phone 1 communicator format

Location 2 has one segment of numerical data. Use this

location to program the communicator format used to tran

to the receiver connected to phone 1. Refer to your central

station receiver documentation to determine which format is

compatible. Table 4 below describes the formats for this

locati

on. If you need a format other tha

communic

ator format” on page 5

format. Progra

m a 15 to create a speci

the entries in L The default i

co mmunicator is disabled a

4V nctions as a lo ly control.

ats

Da Format Description

0 Local nicator is disabled Commu

1 Universal 4+2 vent code 1800 Hz transmit

und parity

Two-digit e

2300 Hz handshake double ro

40 pps

2 3+1 fast (or 4+1)

One-digit event code 1900 Hz transmit

1400 Hz handshake double round parit

20 pps

3 Reserved Reserved

4 Pager

Two-digit event code DTMF

transmissio

5 3/1 or 4/1 slow 1800 Hz transmit 2300 Hz handshake

double round parity 20 pps hex

capability

6 3/1 or 4/1 slow 1800 Hz transmit 1400 Hz handshake

double round parity 20 pps hex

capability

Data Format Description

7 3/1 or 4/1 fast 1800 Hz transmit 2300 Hz handshake

double round parity 40 pps hex

capability

8 3/1 or 4/1 fast mit 1400 Hz handshake 1800 Hz trans

double round parity 40 pps hex

capability

9 3/1 or 4/1 fast with transmit 2300 Hz handshake

y 40 pps hex capabilityparity

1800 Hz

single round parit

10 3/1 or 4/1 f

parity

ast with

ake

pps hex capability

1800 Hz transmit 1400 Hz handsh

single round parity 40

11 4+2 express Two-digit event code DTMF

transmission

12 4+2 fast Two-digit event code 1900 Hz transmit

1400 Hz handshake double round parity

20 pps

13 Ademco contact ID DTMF

14 SIA Frequency shift keys

15 Custom format See “Location 18 - Custom

communicator format” on page 5

16 3/1 or 4/1 slow Same as 5, but sends the alarm event