
IFS NS3552-8P-2S AND NS3550-2T-8S User Manual
2.2.3 Wall Mount Plate Mounting
To install the Industrial Managed Switch on the wall, please follow the instructions below.
In the installation steps below, this Manual use NS3550-2T-8S (IFS
8 Port Industrial Gigabit Switch) as
the example. However, the steps for IFS Industrial Gigabit PoE+ Switch are similar.
Step 1: To remove the Industrial Managed Switch from the DIN-Rail, use the screwdriver to loosen the screws and remove the
DIN-Rail.
Step 2: Place the wall mount plate on the rear panel of the Industrial Managed Switch.
Step 3: Use the screws to screw the wall mount plate on the Industrial Managed Switch.
Step 4: Use the hook holes at the corners of the wall mount plate to hang the Industrial Managed Switch on the wall.
Step 5: To remove the wall mount plate, reverse steps above.
Comentarios a estos manuales