Interlogix TruPortal Manual de usuario Pagina 15

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 138
  • Tabla de contenidos
  • SOLUCIÓN DE PROBLEMAS
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 14
TruPortal Software User Guide 3
CHAPTER 2 Installing Hardware
The first step in setting up the System is to install the hardware components that will be used by the
System (inputs, outputs, doors, readers, cameras, etc.) according to manufacturer instructions. Be sure
to record data about door configurations that can be used later in naming the devices, reader groups,
and areas when the devices are configured in the User Interface.
Note: Existing TruPortal 1.0 or goEntry 3.0 customers that already have all hardware installed
and configured can skip this step and use the Upgrade Wizard to upgrade the System
Controller. See Using the Upgrade Wizard on page 11.
After installing hardware components, connect the System Controller to a local client workstation or
to Local Area Network (LAN), and then use the Installation Wizard to detect the System Controller
on the network, as described in Preparing for Configuration on page 7.
Vista de pagina 14
1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 137 138

Comentarios a estos manuales

Sin comentarios