Interlogix Concord 4 REV C Installation Manual Manual de usuario Pagina 9

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 11
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 8
Concord 4 Installation Guide 9
Specifications
Pow er requirements
Class 2, 16.5 VAC, 40 VA, 60 Hz (600-1023 or
600-1024)
Rechargeable battery: 12 VDC, 4.5 or 5.0 Ah
lead-acid (60-681) or 12 VDC, 7 Ah (60-680).
The battery w ill last 24 hours w ith no AC and
specified stand-by load.
Auxiliary pow er
output
1.0 A at 9 to 14 VDC (12 VDC typical)
Radio frequency
319.5 MHz
Nominal RF range
1,000 feet (305 m) typical open air
Storage temperature
-30 to 14F (-34 to 60ºC)
Operating
temperature
32 to 120ºF (0 to 49ºC)
Maximum humidity
85% relative humidity, noncondensing
Dimensions (H x W x
D)
14 x 12 x 3 in. (35.6 x 30.5 x 7.6 cm)
Regulatory information
UL listed installations
This section describes the requirements for UL listed
installations.
Basic system:
Control panel (600-1021-95R Concord 4 RF, 600-1022-
95R Concord Express V4, 600-1040 Concord Commercial
V4, or 600-1042 Concord 4 Hybrid).
Standard class 2 16.5 VAC, 40 VA power transformer 22-
145 or 22-156 (600-1023), 22-156-CN, or 22-145-CN
(600-1023-CN), or power line carrier class 2 16.5 VAC, 40
VA power transformer 22-149 (600-1024) or 22-149-CN
(600-1024-CN). You must order these transformers
separately from UTC Fire & Security.
Backup battery 12 V 4.5 or 5.0 Ah (60-681) or 12 V 7 AH
(60-680).
SuperBus 2000 fixed display touchpad (60-820), FTP
1000 (600-1020), 2x16 LCD touchpad (60-746-01), ATP
1000 (60-983), ATP 2100 (60-985), ATP 2600 (60-984),
2x20 LCD touchpad (60-803), or 2x20 VFD touchpad (60-
804).
Interior speaker siren (60-528), hardwired interior siren
(13-949), or speaker siren (13-060).
Basic system but also include a SuperBus 2000 RF
receiver (60-764-95R-01) or a SuperBus transceiver (600-
1025-01-95R).
Household burglary alarm system unit (UL 1023)
Basic system plus the following:
Hardwired magnetic contact (13-068 or 13-071) or
wireless learn mode door/window sensor (60-362)
Immediate beeps set to on.
UL 98 options set to on.
Receiver failure set to on (if wireless devices are used).
Siren verify set to on.
Exit delay set to 60 seconds.
Quick exit set to off.
Siren timeout set to 4 minutes or more.
Entry delay set to 45 seconds or less.
RF TX timeout set to 24 hours (if system includes built in
receiver or SuperBus 2000 RF receiver or SuperBus 2000
RF transceiver and wireless burglary sensors).
Extended delay set to off.
Sleep time set to off.
Two trip error set to off.
Alarm verify set to off.
Disable trouble beeps set to off.
Household fire warning system (UL 985)
Basic system plus the following:
Wireless smoke sensor 60-506-319.5, 60-848-02-95, or
TX-6010-01-1 learned into sensor group 26.
Immediate beeps set to on.
UL 98 options set to on.
Receiver failure set to on (if wireless devices are used).
Siren verify set to on.
Sleep time set to off.
Siren timeout set to 4 minutes or more.
Two-trip error set to off.
Disable trouble beeps set to off.
RF TX timeout set to 4 hours (if system includes built in
receiver or SuperBus 2000 RF transceiver and wireless
smoke sensors).
UL 1023 and 985 24-hour backup
For 24-hour backup, the total current draw for all
connected devices is limited to 90 mA (during normal
standby conditions) using a 4.5 or 5.0 Ah battery, or 190
mA (during normal standby conditions) using a 7.0 Ah
battery.
SIA system requirements
SIA system requirements are the same as those
described for a UL-listed basic system. If multiple
annunciation is required, use additional touchpads. This
applies to model numbers 60-746-01, 60-803, 60-804,
60-820, 60-983, 60-984, 60-985, and 600-1020. UL
requirements take priority over SIA requirements.
Table 11 on page 10 describes programming
requirements to meet ANSI-SIA CP-01.
Vista de pagina 8
1 2 3 4 5 6 7 8 9 10 11

Comentarios a estos manuales

Sin comentarios