Interlogix Simon XTi CDMA Module V4 Manual de usuario

P/N 466-2874 • REV B • 06MAR13 Simon XT/XTi CDMA Module V4 Installation Instructions Content Contact information ...

• Before affixing the panel to a wall, verify the CDMA signal level at the installation location. On the XT panel, press and hold the 5 Key for 10 s

Power UpReconnect panel battery and AC power. When a CDMA module is connected to the control panel, the LEDs at the bottom of the module will become

Servers Connecting… In the process of connecting to Alarm.com Updating… Updating Signal Level In addition, some of the information can be retrieved

It also occasionally flashes in patterns to indicate Z-Wave status. See the Table 5 below for a description of various possibilities. Table 5: Z-wave

L3 - Communication with Alarm.com L4 - Alternates two seconds on, then two seconds off L5 - Inactive Sleep Mode. The panel is not connected to AC pow

sensors that did not report correctly. It is available only to installers who have integrated their sensor testing process with the Central Station an

to enable Z-Wave services on the account. --- Add Device2 Add Z-Wave devices to the module’s network. Make sure the device you are trying to add is

Simon XT/XTi CDMA Module V4 Installation Instructions 9 other commands.) ---- Replicate Mode2 Initiates replicate mode on the panel. ---- Send Node