Interlogix NX-590NE Manual de instalación descargar pdf (Pagina 10)

8 NX-590NE Internet Interface Installation Manual

2. Connect the J3 screw terminals or the J19 plug terminal to the control panel

keypad databus.

J3 pins

J19 pins

Pin 1 - NX bus (Data)

Pin 1 - +12VDC

Pin 2 - Ground

Pin 2 - No connection

Pin 3 - +12 VDC

Pin 3 - Ground

Pin 4 - NX bus (Data)

Note: The J6 console (DB-9 female) is used by the factory to troubleshoot and

test the board. The J9 PIC upgrade connector is used for future upgrades to the

PIC processor.

Table 1 below shows the minimum wire gauge and maximum wire length allowed

for the NX-590NE.

Table 1: Minimum wire gauge by length

Length in feet

250

500

1000

2000

Connected to NX panel

Connected to NX-320E

LEDs

Table 2 below describes the LEDs on the NX-590NE board

Table 2: NX-590NE LED indicators

LED

Description

DS1

Flashes each time the NX-590NE has an opportunity to access

the NetworX bus. It should flash about two times per second.

DS2

Flashes when communicating with NX bus (Data).

DS3

Flashes when waiting for UCSIMM acknowledgment.

DS4

Flashes when waiting for NX bus (Data) reply.

DS5

Flashes when message received from NX bus (Data).

DS6

Flashes when message sent to NX bus (Data).

DS7

On when U-Boot is running. Flashes when U-Boot is stopped,

either an error has occurred or stopped via console. Off during

application.

DS8

On when uClinux Kernel coming up, then shows an application

heartbeat.

DS9

On when power is on.

Table 3 on page 9 describes the LEDs on the UCSIMM module

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 37 38

Comentarios a estos manuales

Sin comentarios

Interlogix NX-590NE Manual de instalación Pagina 10

Comentarios a estos manuales