Interlogix Simon XT Tabletop User Manual Manual de usuario Pagina 30
- Pagina / 58
- Tabla de contenidos
- MARCADORES
Valorado. / 5. Basado en revisión del cliente
24 Simon XT TableTop Control Panel User Manual
• Communication troubles with the central monitoring station
When your security system detects one of the problems above, six rapid beeps
sound every minute until the trouble condition is corrected. To stop the trouble
beeps, press Status or arm/disarm the system while the trouble condition exists.
Trouble beeps will resume four hours later unless the trouble condition is
corrected.
The following list explains the trouble beep conditions:
AC power failure
This condition (if programmed by installer) occurs if your security system has
been accidentally unplugged or if there has been an AC power outage. Any
status lights go out immediately, and trouble beeps start after five minutes. If you
press any button, the display will light and pressing Status will show the AC
failure. If AC power is not restored within a programmed period of time (5 to 254
minutes) the system will call the central monitoring station. The backup battery, if
fully charged, will last for 18 to 24 hours—depending on the load applied to the
panel—with no AC power.
System battery failure
This condition occurs if the emergency backup battery has failed. Trouble beeps
will start. Press Status and the display will show System Low Battery. If your AC
power is not working, your security system will shut down once the battery has
failed. If the condition does not clear after AC power has been restored and 24
hours have passed, call your security system dealer.
Restoration of power
This condition occurs after a complete loss of power (AC and battery). When
power is restored, the panel will return to the arming state with the same zones
bypassed it had prior to losing power.
Sensor failure
This condition occurs if a sensor is not communicating with the panel. Trouble
beeps will start and the Status button will light. Press Status and the display will
show what sensors have failed. Perform sensor tests. You may need to call your
security system dealer if the problem continues.
Sensor low battery
This condition occurs if a system sensor has a low battery. The sensor may still
be communicating with the panel. Trouble beeps will start and the Status button
will light. Press Status and the display will show what sensors have a low battery.
- Simon XT TableTop Control 1
- Panel User Manual 1
- Content 5
- Preface 6
- Chapter 1 7
- Introduction 7
- Security system components 8
- Chapter 2 11
- Using the control panel 11
- Panel controls 12
- Panel features 14
- Things you can do 15
- Home security 15
- Exit/entry delay 17
- Bypassing sensors 19
- Light control (optional) 21
- Using and offsite phone 22
- Using touchpads 23
- Handheld touchpad 24
- Simon XT TableTop Touchpad 24
- Chapter 3 27
- How your system 27
- Status beeps 28
- Panel indicator lights 29
- Trouble beeps 29
- Chapter 4 33
- Programming 33
- System menu 34
- Top-level menus 35
- Set clock 36
- Light schedules 36
- Sensor lights 37
- Special chime 37
- System programming 38
- Access codes 39
- Security 40
- Phone numbers 40
- Siren options 41
- Light control 43
- Chapter 5 47
- Testing 47
- Testing sensors 48
- Testing communication 49
- System download 50
- Appendix A 51
- Reference information 51
- Emergency planning 52
- Your floorplan 54
Relacionado con productos y manuales para Panel De Control Interlogix Simon XT Tabletop User Manual
(2 paginas)Canon Dispositivi multifunzione manuali utente
Partendo da P
Comentarios a estos manuales